SKR 1.4 (Turbo) Case & Magnetic Lid (ENDER 3 PRO)

thingiverse

I just got a SKR v1.4 Turbo and I wanted a nice case easy to print and with honeycomb. I updated the Case and Lid, with better tolerances for the magnets as I struggle a bit to make them fit in their place. Also the files are already on printing position. TO COME: Change orientation of honeycomb in order to improve printing (To be released soon) ----------------------------------------------------------------------------------------------------------------- DOESN'T NEED SUPPORT! - You can print on this orientation BUT enable BRIDGE SETTINGS on CURA - Put the Fan when the printer is doing the bridge so it will print on top of the fan (Or use supports but this procedure saves you 6h) ----------------------------------------------------------------------------------------------------------------- MINOR UPDATE: - Added a 3030 Fan Cover for the sides. ----------------------------------------------------------------------------------------------------------------- 1. I designed this case to just slide in place and use the two original bolts for holding it in position. 2. For the lid, I used six magnets that are 6mm x 1mm. 3. In total, I am running three fans: - Two 30x30 24v Fans on the sides. - One 40x40 24v Fan on the lid. 4. For hardware, you will need: - Four 3m Bolts that are 15mm x 15mm for holding in place the SKR board and reaching the shoes . - Eight 3m bolts that are 15mm x 8mm for the lateral fans . - Four 3m bolts that are 20mm x 4mm for the fan on the lid. - Eight 3m Screws to insert into the shoes and the lid fan. 5. Use settings for 0.28 but with an initial layer at 0.2 for a better look.