SKOUT Epoch Adjustable Bag Rider

prusaprinters

Adjustable bag rider for the SKOUT Epoch which utilises 4 holes under the rear stock.As with all 3D printed holes, much is depended on your printer/filament settings and how good your printer is tuned but there should be enough space for a ¼"-20 screw to pass though the holes no matter how low print quality is.You will need 4 ¼"-20, 25mm (1") long screwsWhole setup is quite sturdy and stableI've used PLA but for durability outside I would recommend ABS, ASA or PETG for higher temperature resistance in the sun.Print in upright orientation with support from build plate only for the upper partPrint with support for the lower partI've printed thumb screws from TPU but any material can be usedThis design uses M10 lead screws because those are readily available in EuropeGlue the M10 screws to the thumb screws in place