Skipping Rope Handle with 608 Bearing

prusaprinters

<p><strong>Skipping Rope or Jump Rope Handle</strong></p><p>It features a standard 608 skateboard bearing. It is held together using four self-tapping wood screws. Each handle consists of three parts, the front and back of the handle and the knot holder.</p><p>The picture shows one of the handles after seven months of use so it's a bit battered but still working perfectly fine.</p><p><strong>Printing</strong></p><ul><li>Printed a full set of two handles together in one print.</li><li>0.20mm QUALITY</li><li>Generic ABS</li><li>Supports: Everywhere</li><li>Infill: 30%</li><li>Print Time: 13h5m</li></ul><p><strong>Assembly</strong></p><ul><li>The rope is 4 mm in diameter</li><li>Cut the rope to length</li><li>Mount knot holders in the bearing&nbsp;</li><li>Put the bearings and knot holders on the rope</li><li>Tie a knot at the end of the rope and put into the cup of the knot holder.</li><li>Stop the knot from untying by either using, superglue on the knot, or if nylon rope is used the knot can be melted slightly.</li><li>Screw two shells together using 3.5mm x 20mm self-tapping wood screws (ensure Screws do not protrude through the shell)</li></ul>