SKimmer + Net + Pool Hangar

thingiverse

I have been looking through various Thingiverse listings and really liked the skimmer hack but my pool setup is different I have the more oval bars than the round ones. Mine is the Coleman 18ft Above Ground with the port holes in the sides, I am very new to remixing but gave it a shot. I plan to zip tie a Leaf net (URL Below) which I have not purchased yet to this and hang it in front of the filter output or pool return. https://lesliespool.com/right-fit-leaf-rake-pool-cleaning-attachment/20451.html I have yet to print it. I will probably use 50% infill for strength. You might can reduce this. I use PLA+ in a Dremel 3D20 (no heated bed) ABS or PETG may work better This is a work in progress I thought about making additional holes for a zip tie to help hold the hangar in place. I printed it but it is too small for my pool support rail. The inside measured of the clamp is 61.8mm but I need 77mm. I scaled up 20% using Cura and will try again. This may work for someone. In V2 I moved the holes on the top up a little and made them just a little bit bigger. I will include a picture of the print I did. I turned on ironing which did not work as wel as i had hoped. There are some lines that it left in the top layer but if this had been the right size I think the part would have been plenty strong.