Ski Holder Button (and Snowboard Holder Button)

thingiverse

These ski buttons are easy prints and can hold the weight of a set of skis each. I screwed a board to the wall and then these buttons, one each, for each set of skis we own. The button is intended to fit inside the front of the ski bindings (where the toe of the boot goes) and the other ski is held up by interlocking the brakes, as shown in the photos. I included an extended version that will hold a snowboard too. The print settings are populated and I suggest printing it in the orientation shown in the yellow model picture (base of button on the bed of the printer). I didn't need an adhesion layer, but you may depending on your filament and settings.