SKG Remote Fob Holder Sun Visor - Remix on hashg's garage opener holder

thingiverse

This model is designed to hold a SKG Remote Fob to your vehicle's sun visor securely. To use it, you'll need a 1 1/4 inch Binder Clip, which can be easily found at most retail stores or purchased online. I've been using hashg's original design for months with excellent results. However, over time the 'bottom' cap eventually came loose due to potential heat damage. Despite this, one print has lasted more than five months and still serves its intended purpose, although it shows some noticeable wear. Recently, I experimented with TinderCAD by remixing hashg's design to add a wedge-shaped feature at the bottom for extra support and to prevent the fob from being pushed further into the case. I also increased the height of the front plate to keep the edges together, ensuring that when pressing the Fob buttons, the fob moves up higher in the case. These modifications do lengthen print time, so it's essential to decide which version works better for your specific use case. I'd like to thank hashg again for providing this model, which has eliminated the hassle of searching for my car's console for the fob. It took 2 hours and 24 minutes to print on a Creality CR-10 at a speed of 50 mm/s.