Skewer Flyer

prusaprinters

MaterialPrint 4× ribs (or add more thin ribs), connector, tail and nose13cm paper or foil 3 skewer ∅ 3mm4 × rubber bandstape AssemblyPut 2 skewer through the 4 ribs and space them equally. Ribs are  asymmetrical NACA 2412 profiles - make sure they all align.Use loom rings or any rubber band that stretches around a rib (12 cm) to fix some foil or just thin paperUse a 13-14cm stripe and overlap so the top layer is with the flow ⇒ —____Use some tape if needed.Make an incision so the connector fit in and clip another skewer with the nose attached onto. Add the tail and put folded paper into the slitstest ⇒ Fly .. ⇒ adjust ⇒ Fly ⇒ repeat