Skew print test 280mm x 280mm

prusaprinters

<p>Skew print test</p> <p>This is a version I made from <a href="https://www.thingiverse.com/thing:2805032">https://www.thingiverse.com/thing:2805032</a> design. My use is to verify / adjust CoreXY belts to correct any Askew alignment without modifying software.</p> <p>I needed a larger version for my 300mm x 300mm bed. This is 280mm x 280mm</p> <p>Also I made things larger and easier to see if anything is askew.</p> <p>Placing metal straight edge in 2 corners will press up against large areas, if 2 corners and center all touch with no space at any point all is good. Then check other direction.</p> <p>The idea is by looking you could measure how off one side is without using a measuring device. Ideally not even a thin film or measuring shim will fit between the straight edge and any of the 3 points. Not perfect but once you start tightening the belts you can notice the changes and hopefully help to get finial alignment.</p> <p>The means I adjust my Z9M3 CoreXY printer can be found here. <a href="https://www.thingiverse.com/thing:3038877">https://www.thingiverse.com/thing:3038877</a></p> <p>This file so far for me has been to verify, I properly adjusted the belts, so I have not used this yet to Fix Askew alignment, just used it to verify I was good</p> <p>Enjoy!</p> <p>`mike</p> Category: 3D Printer Parts