Skeletonz Poseable Fridge Magnet

thingiverse

This is a remix of the outstanding 'Skeletonz' model from muzz64. The only changes made were scaling it up by one-fifth and adding holes for five 9mm magnets. Other magnets visible in the second picture are Bender, Minion, Batarang, Tardis, Space Invader, Octopus. Print Settings: Rafts - No Supports - No Resolution - 0.2mm Infill - 20% Notes: The original model suggested a denser infill and four shells, but I found it unnecessary; results may vary. When printing, I rotated the model by 180 degrees to ensure the presentation side faced down on the print bed. Either orientation should work well. Post-Printing: Gently manipulate the joints after printing as they might be somewhat stiff - you should hear a slight click as they release themselves. If they snap or become completely fused, try reprinting with a lower extrusion multiplier. I used blutack to hold the magnets in place, which should work with both PLA and ABS (my print was made of PLA).