Skadis Mount for Lenovo Tab M8 Gen 2 and Gen 3
prusaprinters
This is a mount to attach a Lenovo Tab M8 to an IKEA SKÅDIS pegboard. It uses the Skadis T-Nuts for a very secure hold and easy installation. It's sturdy and there's no wobble. The fit is tight. Don't be afraid to press pretty hard until it snaps in place.Read more about the Skadis T-Nuts Mounting System and check out the Skadis T-Nuts Collection for more Skadis accessories that use T-Nuts. There are separate STL files for Gen 2 and Gen 3.ModelGenerationPrintable fileLenovo TB-8505FGen 2Tab M8 Mount Gen 2.stlLenovo TB-8506FGen 3Tab M8 Mount Gen 3.stl BOMQtyDescriptionSourcing4M2.5 DIN934 Hex NutAliexpress4M2.5x10 (or longer) Socket Head Cap ScrewAliexpress Printed PartsQtyPart2“Tab M8 Mount Gen 2.stl” or “Tab M8 Mount Gen 3.stl”4“Skadis T-Nut M2.5.stl” PrintingPrint the part in the original orientation. All the STL files are pre-rotated.Material: PETG (slight flex, good for installation)Extrusion width: 0.45mmLayer height: 0.2mmPerimeters: 4Infill: 0%Solid top / bottom layers: 4 Mounting OptionsYou can use two mounts and place them wide apart. You will have to install the tablet slightly offset because the rear camera is in the way.You can also place the mounts narrowly. Pay attention to the power and volume buttons. The left mount has to be between the buttons.If you don't want to interact with the tablet (no touching) you can also use a single mount in the middle. AssemblyPush the M2.5 hex nuts into the T-NutsStick the M2.5 screws through the holes in the printed mountScrew the T-Nuts onto the M2.5 screws until the distance between the bottom of the mount and the T-Nut is about 2mmOrient the T-Nuts verticallyStick the assembly through the holes on the Skadis pegboard in the desired configuration. The part should self-align.Tighten the screws but do not over-tighten. Install the DisplayPlace the lower edge of the tablet in the lower hooks of the mounts and make sure it's well seated.Firmly push the upper edge of the tablet into the upper hooks of the mount until it securely clips in. Pay attention to the rear camera if you use wide mount placement or the power and volume buttons when using a narrow configuration!You might have to push quite a bit as it's a tight fit. The PETG should have enough flex if printed using the above instructions and will not snap.
With this file you will be able to print Skadis Mount for Lenovo Tab M8 Gen 2 and Gen 3 with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Skadis Mount for Lenovo Tab M8 Gen 2 and Gen 3.