Skadis Hook (Extra-Small Shelf)

prusaprinters

<p>Print in PETG using standard PETG printing parameters or some other tough plastic like ASA. &nbsp;I used Inland PETG and printed with Prusa's generic PETG parameters and infill 50%. &nbsp;Part is thin, so infill 15% will be fine. &nbsp;But, higher infill is desirable for heavier loads.</p><p>BE CAREFUL PULLING OFF BED. &nbsp;Adhesion is fine on smooth plates. &nbsp;No brim/raft required. &nbsp;Part is liable to break in thin places if pulled off plate without care.</p><p>Superglue parts down the seam to assemble. &nbsp;Parts also work fine without superglue.</p><p>I use this to hold my split keyboard(s) and gaming controller(s). &nbsp;I see potential use for figurine collections, holding small containers, and holding/displaying other things.</p>