SKADIS Filament Spool Holder Remix (Widened)

cults3d

A slight modification to the excellent SKADIS Spool Racks mode by alecs_from. I found that at their narrowest setting the racks were too little snug for the pretty standard 66-68mm wide spools I get from MicroCenter. Not wanting to spread the racks out and lose storage space, I instead offset the hooks on each one out by 4mm, thereby providing a bit more storage room at the expense of free (unused) space between the sets of racks. This does make all five hooks require supports now as they are all off the bed, although the lowest ones don't require much. I also thickened the entire rack by 4mm to accommodate the now shifted hooks. To offset the extra printed material, I cut off a bit off the bottom bumps that hold the spool in place, as it wasn't necessary for the spools that mare taking up the full width of these racks anyhow. Because everything is thickened a slight bit, these racks also have slightly thicker infill panels like the originals. Finally, as a bit of a quality of life improvement, I embossed each rack with their type (AR, AL, BR, etc.) so it's easier to tell them all apart. I haven't gotten around to the D or E racks yet, but once I get to the bottom of my pegboard, I will!