Skadis Easy Filament Spool Holder

thingiverse

If you like this original print, donations are appreciated: www.paypal.me/ahplua After trying multiple other Skadis/Skådis spool holders on here, none of them fit. I'm not sure if they changed the design of the peg board but the holes in the peg board was too small to fit anything in, didn't fit my standard spools, or i didn't like the designs as some where too complex. This design is extremely simple, and you can print directly from the spools hanging. This is a very easy, very simple spool holder. Basically nothing can go wrong. It is not the most optimized design, but it's basically failproof. No supports, no overhangs, no small tolerances, no fuss. The design is only two parts, a left and a right, that clicks together in the middle. The middle part is somewhat loose by purpose, after making multiple version that were so tight i couldn't get them apart again. Since you need to take it part when changing spool, i made it nice and easy to take apart. Again, i am not sure if they changed the design of the peg board, but as of July 2023, this fits the Skadis peg board they sell in Denmark. I don't know about other countries. Also right now it is just made for my size 1kg Spectrum spools which i feel is fairly standard, if requested, i can make more sizes. Max spool dimensions: 20,4cm diameter 7,2cm width Personally i printed in PETG with 20% infill, but I assume it works fine in PLA as well.