Skadis Caliper Hanger for Smaller Calipers

prusaprinters

I really liked how the original caliper holder turned out, but it was too big to store my smaller calipers without them sitting with a pretty good tilt to them.  So I reworked it a little to make the gap a bit smaller and to raise up the one side about 1/8 of an inch. Overall, there is a 1 inch (20mm) gap in the middle.  This should fit most of the 6 inch digital calipers out there, with just enough wiggle room to make accessing the tool easy.For the hexes and hooks, please see the original model.Enjoy!