Single WS2812 LED Holder for GepRC ZX4, ZX5, ZX6

thingiverse

A straightforward holder for one addressable LED (e.g. https://www.aliexpress.com/item/100pcs-ws2812-individually-addressable-rgb-full-color-ws2812b-led-emitter-chip-with-white-black-heatsink-dc/32619250295.html) that fits onto existing two vertical spacers is what I need to build the ZX5 in plus configuration. There's a gap at the bottom because of this, making it easy to run your battery cable through if you're building an X. To print this STL file, simply flip it 180 degrees and get some support around where the LED will sit so it stays round. Once printed, solder three wires onto the rear pads of the LED, then run them through the hole. Place the LED on the mount with a drop of superglue on the back where it touches. Press together and hold until the glue sets, then after you're installed, use hot glue to fill in your solder joints on the LED and a bit extra for good measure - this should keep everything problem-free.