Single shot loader for FX airgun, 30 caliber, 7.62mm

cults3d

This is a loader for most FX airguns (except Impact & Crown models). Photo's show it mounted in a Verminator MkII, so it should also fit in FX Bobcat MkII for Europe and FX Wildcat MkII. I found the trays where a pellet rolls into place quite difficult to operate in the field. It allows easy loading of pellets up to 13mm, such as the Predator Polymag .30. This will not fit into the factory magazines. To assemble the two parts, using at least: a 3x15mm screw/bolt, stainless steel preferred & a 3mm nut, stainless For easy removal, I recommend also adding the back screw as gripping point. Then add 1 more screw and 2 more nuts. It is a .30 caliber or 7.62mm model, since I own the gun and have tested it. Also, the fit is quite specific. Push it all the way in from the left side. Too tight? A little bit of sanding helps. Too loose? Touch a few points with the tip of a soldering iron. You can see on my print where I did that after a little too much sanding. Be delicate. You want to open and close the loader without the base moving. Removing it is easiest with the screw/bolt on the left side. Glue the screws into all 3 of the nuts using Loctite 242 (blue).