Single Pool Hose Hanger

thingiverse

I wanted single ones so I could place them as close or far apart as I desired. So, I cut the original design and added two more holes for screws - adding a single hole would create a pivot point that might let the hanger move. The middle one was left in case you'd like to use the single attachment like on a pegboard or something. Prints perfectly on the side with no supports needed. Just make sure it's oriented correctly in the STL file, but you never know for sure. I printed mine using PLA since I haven't played around with PETG yet. However, they should be fine - just pick your material at your own discretion. In Cura, the estimated time says 1 hour and 31 minutes with 15 grams of filament. For a better idea, I printed eight of them once and it took 12 hours and 28 minutes with 118 grams of filament.