Single Din Pocket Plus Custom Files

thingiverse

I've uploaded a simple pocket design along with what you see pictured, minus the slots for the voltmeter and the switch. I've also attached the Fusion 360 file so you can modify it if needed. I'm not sure which holes this will fit into, but it fits perfectly in my 2000 Tacoma, and my understanding is that these holes are relatively universal. If you're curious about what the rest of my project was all about, read further down. Most importantly, don't print this in PLA - PLA has a glass temp that's too low for use inside vehicles. I chose to use PETG because it prints easily and has a high enough glass temp. ABS would also work well, so pick your material carefully. I've had this idea in mind for a project for a while now, and I couldn't find anything that fit my needs. I wanted two LCD Voltmeters for the two batteries in my truck, which required a "Double Pole Single Throw" switch to have the voltmeters run to each battery separately yet only need one switch to turn on both. The voltmeters I used can be found here: https://smile.amazon.com/gp/product/B00BZPH6KQ/ref=oh_aui_search_detailpage?ie=UTF8&psc=1, and the switch I used is available here: https://smile.amazon.com/gp/product/B00004WLK9/ref=oh_aui_search_detailpage?ie=UTF8&psc=1. Print Settings Printer: Qidi Tech 1 Rafts: No Supports: Yes Resolution: .2 Infill: 20% Notes: Most importantly, don't print this in PLA - PLA has a glass temp that's too low for use inside vehicles. I chose to use PETG because it prints easily and has a high enough glass temp. ABS would also work well, so pick your material carefully. I ran this with 20% support, the last three layers of support were 40%. I printed face up (pretty side ends last) with six layers on top to ensure complete fill on final layers. The Single Din with only the pocket doesn't need any support and should print fine without it.