Sinder Trigger Fix Mod - Reinforced - V2

thingiverse

I remixed @Kevman323 remix of @Hexxed original model. Main changes here are I lowered the ring where the spring sits for better fitment and added a more pronounced "slot" for the spring to fit in (helps when reassembling). Also there is a slightly more agressive slant on the top block to allow some extra return travel on the trigger. None of these may really be necessary over the first remix, but I had trouble getting the remix to fit originally and there was very little trigger movement for me. I may have been able to just file it down, or it may be my printer is getting sloppy. Anyways, I currently have these installed in my 2 sinden guns, they fit better for me. Things I learned while doing this: elephant foot is bad, any of it will cause fitment issues.. I had to file down all the elephant foot edges (my printer is good at creating them) One of my springs had 2 long ends, for this to fit, one of the spring ends should only be about 3/8" so it fits in the little slot. I had to cut it. The short end is lower, and points right. I still had to file both the top and the trigger back stops to get the right amount of play I was looking for. This is obviously preference, but yea, I had to increase travel a smidge by filing down both surfaces to be happy. Could be related to sloppy tolerances also, but the default amount should "work" but I wanted a little travel (like 1/8-1/4") rather than a button type feeling. Putting it back together is a bit of a pain. Be careful to look for lining up the camera circuit board, the lens in front of camera, the wires (in between the screw posts), and if recoil the metal hitting square the solenoid clacks against.