Simplify Quail Eggs Turner for Incubator (Arduino Powered)

thingiverse

Inspired by SnakeJayd's innovative design, I've adapted the concept using a servo motor and an Arduino Uno board that I already possess. To streamline the design and reduce printing time and material usage, I've opted for utilizing an existing quail egg tray from my local supermarket as the base. **Caution:** Upon initial startup, the Egg Turner will rapidly move to its default position. The speed is so swift that it may potentially damage your eggs or dislodge them. To prevent this, please remove the entire egg tray before powering up or resetting the device. The programming has been modified from SnakeJayd's original code to suit my needs. It is currently set to repeat every 3 seconds for testing purposes; however, I recommend following the instructions in the comments to adjust it to rotate every 2 hours. Required components: 1x SG90 Micro Servo Motor 1x Arduino board 2x Nails (1.5mm wide) 1x Zip tie (secured tightly on a nail as a stopper) 1x Quail egg case **Update:** 10/05/2019: A new base, dubbed "Low," has been introduced, which is 18mm lower than the original design. The latter has been renamed to "High." 13/04/2019: The Arduino code has been updated to address an issue with integer limits on the Uno board, ensuring that the delayTime function works correctly even when set above 32 seconds.