Simplified mag release for nerf half dart magazine adaptors.

thingiverse

This modification enhances the mag release lever for increased strength and minimizes the number of components required to print Tungstenexe magazine adaptors for Nerf half-dart magazines, such as the Vorpal mag. Rather than employing a separate two-part axle and additional pins to secure them in place, I've utilized a single axle that traverses the entire magwell body, reducing the assembly from six parts to three. This adaptation also allows for the use of a metal pin instead of the printed part if it is glued into position. Additionally, the hole through the mag release arm has been enlarged to increase its strength. A significant improvement was made by adding an over-insertion lip to the flywheeler version, which was notably absent from the original upload.