Simplified bracket for Active Cooling Fan Duct - Duplicator 4 / Replicator 1

thingiverse

In my quest for m3x60 bolts, I discovered a bracket for attaching an Active Cooling Fan Duct (http://www.thingiverse.com/thing:295317); however, it failed to adhere properly. To rectify this issue, I undertook a significant redesign, allowing the bracket to attach at the two small holes in the gantry, into the linear bearings. This revision also made the design smaller and simpler. You will now require 2x m3 14/16mm bolts and 2x m3 nuts. The updated bracket slides beneath the nozzle fans, with the taps fitting securely into the small holes. Attaching the fan duct tightly to the bracket around the gantry ensures that the taps cannot move up or out of position. The slightly wider spacers also aid in horizontal alignment of the fan duct. However, this design is specifically tailored for Wanhao Duplicator 4x printers, and it is uncertain if all dimensions are comparable to Replicator 1. For FlashForge or CTC-printers, truit00 created a version that better accommodates their geometry (http://www.thingiverse.com/thing:350649). Note I designed this specifically for the Wanhao Duplicator 4x and I am not sure if all the dimensions are completely similar on the Replicator 1. For FlashForge or CTC-printers, truit00 made a version that fits better with their geometry: http://www.thingiverse.com/thing:350649