SimpleHuman Shower Caddy Stabilizer

thingiverse

I had an older model of the SimpleHuman shower caddy that only had one suction cup, the newer models have two, but either way, I liked the idea of stablizing my caddy on the shower faucet handle firmly without the need for suction cups. Only works if you shower head and faucet are in line (and for dedicated showers mainly, not tubs). Note: It is recommended that you print just a 2-3 layers of this piece first for fit to your shower faucet. As mentioned, print a thin few layers of the stabilizer then stop the print, cut the piece into two and then use the overlap when in place between the caddy and shower faucer to determine how much you need to adjust the length by based on that. I will look at creating an adjustable version of the print, but for now your best bet is to open it in Fusion 360 and adjust the length there. I'm a beginner at F360 so it might take a little bit more magic than it should to shorten. Shortening/Lengthing in Blender or similar might be a easier solution.