Simple V6 hotend mount with part cooling for Two Trees Sapphire Pro SP-3

thingiverse

As original hotend kept on jamming and I had a V6 on hand, I designed this simple bracket to mount it. Mount shortens Y by ~2cm as it mounts on a side of the X carriage. Any attempt of directing air from 4010 fans resulted in much lower output (from already low) so I just left it open. To mount it I used screws from Ender 3 heatblock (M3 16mm). 30mm fan, not pictured is attached by a ziptie through V6 fins. Mount is meant to press on the V6 collars from two sides (bending a little) to the metal carriage. Fans should be mounted with narrower side down as that's where the most of the air comes out. STEP file included. Pros: Probably the lightest setup one can have Easy to print, even w/o part cooling Prints in 30 minutes Solid mount, metal on metal Easy to access, change parts Cons: 4010 fans are weak ~2cm shorter Y does not fix belt alignment problem...