Simple V-Block

thingiverse

This is a basic V-block that's not really meant for actual use, although theoretically it could be used if you need it. Since it's drawn up in inches, you'll likely have to scale it down if your slicer uses metric measurements like Cura does - and I'm sure most others do too. I'm no expert when it comes to 3D printing, and my equipment isn't top-notch, but I took it slow and easy on this one, trying to get the surfaces as accurate as possible. I used a 20% infill rate, but any level would probably work just fine - and I didn't bother with any raft, brim, or skirt settings. This V-block was designed in MasterCam as a simple project to play around with the extrusion feature.