Simple to Print Dice Tower with Storage.

thingiverse

A simple dice tower that relies on pegs instead of ramps, without any need for supports. It performed flawlessly when tested with 16mm dice, as well as tiny 5-6mm dice, and should also work perfectly fine with 19mm dice (I'll update the design once I get some). With a rubber band, you can even use it to store and transport your dice; check out the photos above. Although I did experience one freak occurrence where a die bounced out of the tray, this was likely due to rolling eight or so dice simultaneously with force for scientific purposes. If you allow the dice to roll in naturally, however, the system works perfectly. Requirements: Glue is necessary to attach the front plate to the main body. A rubber band is required to keep the dice tower attached to the dice tray (no need to worry about tolerances). I'll probably update the design with additional runes and logos in the future. If you dislike the Celtic knot on the front, I've included a plain front panel as well.