Simple Spoolholder for Deltaprinter with some bling, 80mm and 95mm

thingiverse

A Simple and Durable Spool-Holder for Kossel Printers is Designed as a Replacement for the Original Holder on Anycubic Kossel Printers. The Original Holder Was Too Short to Accommodate One Brand of Filament with an Unusually Wide Spool, and Its Design Was Also Inhibited by the Screws That Secured It. The 80 mm Version of This Spool-Holder is Slightly Longer and Should Be Sufficient for All 1 Kg Spools. However, It Falls Short for Larger Spools, Where a Stronger Reinforced 95 mm Version Is Provided to Accommodate Them. Mount the Holder on the Side of Your Kossel Printer at the Same Location as the Original One, Using the Same 8 mm Screws. If You Have Corner-Reinforcements Installed, You Can Mount the Holder Directly Above It for the Recommended Height by Anycubic. Alternatively, You May Find a Different Solution Useful. A Noteworthy Feature of This Spool-Holder Is an Inlay That Adds a Touch of Bling to Your Printer Setup. Simply Glue the Inlay in Place for a Nice Finish at Minimal Additional Cost. To Print the Holder, Use Five Walls or Perimeters for a Smooth and Quiet Output. Ninety Percent of the Holder Should Be 4 mm Thick, Achievable with Ten Walls of 0.4mm Each. No Support Is Required During Printing. For a More Complete Spool-Holding Solution, Explore Other Members of This Family of Printers: - Delta or Cased Cubic Printers: Visit https://www.thingiverse.com/thing:3548166 - Cartesian Printer Spoolholders: Find It at https://www.thingiverse.com/thing:3064326 - AnyCubic 4MAX: Learn More at https://www.thingiverse.com/thing:3547789