Simple Speaker Wall Mount

thingiverse

I decided to design my own simple yet adjustable wall mount for my 2.1 satellites since none of the existing designs on Thingiverse met my requirements. Most of them needed additional support during printing or were too bulky for my needs, so I came up with this one on my own. Only two small components are required to attach it to the wall: a single 4mm screw and a 5mm dowel rod. This should provide more than enough stability for most satellite speakers. In my case, I'm confident that the plastic will break before the dowel rod gives way. To join the two parts together, I used an M4 nut and an M4x20mm bolt. However, any length between 18mm and 40mm will work just as well. Before tightening the bolt, make sure to adjust the angle and direction of the mount to your liking. The speaker itself is secured using an M4 bolt, a washer, and a nut. Good luck with assembling this wall mount!