Simple Phone Mount for Bicycle Handlebars

Simple Phone Mount for Bicycle Handlebars

prusaprinters

This is a phone mount which uses 2 M3x12 Screws and 2 M3 Nuts to secure a generic phone (more infor below) to a 22.3mm diameter bicycle handlebar. Assembly:Printed out of TPU (Standard 95A works fine), this uses a tight press-fit connection to hold the case in place. This was printed at 0.12mm layer height at 20% infill, though a 0.25mm offset for the press-fit squares should allow for more accurate printers at 0.2mm layer height to achieve a good result. The arms of the piece wrap around the handbars, and screw together (as depicted in the images), and the case can simple slot on horizontally or vertically to the 5 square pegs. TPU allows for screws to be adjusted, meaning M2 or M4 screws could theoretically work (though I haven't tested these). The hole diameter for the screws is 3.5mm. Application:It works fine for everyday use, and has had no problems holding tight in rocky roads, forest paths at moderate speeds, and getting up and down curbs, though please ensure the press-fit connection is tight enough. (I am not liable for any damage to your phone, if it occurs!)Though this was made for my niche, chinese Vivo x20 (155.9 x 75.2 x 7.2 mm), the phone case should work for most phones today. (158mm x 78mm max | 148mm x 68mm min, thickness of 11mm max). For larger phones, this may be a tight fit!This was designed to be as simple as possible while relying on minimal external hardware, and I hope it helps someone out there improve their biking experience! (This is my very first post, so I would love to read about any suggestions for improvement!)

Download Model from prusaprinters

With this file you will be able to print Simple Phone Mount for Bicycle Handlebars with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Simple Phone Mount for Bicycle Handlebars.