Simple Glass Bed Mount

thingiverse

This simple bed mount was designed to hold securely the 4 millimeter thick glass or mirror print bed, which is commonly used with a heat bed. The design assumes the print bed is the same size as the heat bed. To keep the bed firmly in place, install two back glass mounts and at least one glass mount. When printing, position the pieces according to the slicer software image attached for best results. If you decide to use these parts, please upload a photo of your project and provide feedback - I'll be grateful for your input. Print Settings are as follows: Printer Brand: RepRap; Printer: Geeetech pro X (prusa i3); Resolution: Not applicable; Infill: 100%; Notes: The recommended material is ABS plastic, which will come into contact with the print bed and must not melt. How to Use: The back bed holders are always in place. To secure them, remove the heat bed, reattach the screws, and this time include the bed holders as shown in the picture. Now you can add or remove the front holders at your convenience and take out the print bed whenever needed.