simple frame stand

myminifactory

The frame must have a ledge at the back, and its height should be no more than 25cm. However, it can be quite wide. Printing this frame takes about 15 hours on an Ultimaker². If you use another printer, the print will be slower due to its high design with little surface area. Using a brim is also recommended. The frame is not designed to lean against anything; instead, it should hang from the back ledge and rest on the ground. One of the pictures demonstrates this perfectly. By default, this design is intended for a 19cm high frame at a 75° angle, but you can easily modify these parameters in the Solidworks file. Your printer must be able to print on a surface that is at least as tall as the frame's side against it. Otherwise, this stand has a contemporary look and is quite light, but its shape makes it difficult to ship due to potential breakage and excessive space requirements. My print had unusual zigzags inside the smaller triangle, which I'm not sure were caused by anything in particular.