Simple Floor Sweeper (+TPU)

prusaprinters

A simple floor sweeper (Swiffer) with TPU attachment wipes. Can be used with whatever fits like dryer sheets or old rags. There is a small (140x125mm) and wide (180x125mm) version. This file uses the pole attachment parts from the Dryer Sheet Swiffer by Julius 3E8. Download them from there and give them a LIKE. Supporters can also export them from the source file.Print/Assembly Directions:Print all parts from any hard filament, then assemble with your sweeper pole. The attachment parts include a two-sided spring detent.In my case, there was only one hole, so I drilled through and hammered in a 5mm pin.Print the attachment wipes in TPU, them push into place with the flaps facing up.Changes to original file:Sweeper is a single piece instead of top/bottom.Sweeper is rounded on corners and sloped on the bottom to reduce friction and bumps.Bottom of sweeper has cutouts to reduce warping and make removal from the print surface easier.