Simple Cheap and Easy RDA/Tank Stands

thingiverse

These 22mm and 30mm Tank/RDA stands were designed with style, size, and cost-effectiveness in mind. They keep your Tank/RDA upright for display, organization, or storage purposes, preventing nasty leaks from juice buildup that can leave sticky little rings all over your table and keeping fragile glass on tanks safe and intact. The 510 hole is just the right size to fit a 510 securely without slipping off when picking up the RDA or tank. Printing these stands takes around 10-15 minutes at 15-20% infill, while printing 24 of them requires about 3 1/2 hours. Printer Settings: Printer: Flashforge Creator Pro Rafts: No Supports: No Resolution: 0.2+ Infill: 15%+ Notes: Printing with less than 15% infill can cause the top to sag, especially when using a hex-comb fill pattern during finishing layers.