Simple case for Zachtek CW flea transmitter

thingiverse

This is a simple functional case for the ZachTek CW flea simple transmitter. The case should be printed at .2 mm layer height so the support pads at the back are smooth enough to allow the board to slide in. Three of the button extensions need to be printed and you will probably want to smooth the button holes with a drill bit to allow the button extensions to operate smoothly. The pillars off the lid top should hold the PCB against the bottom of the case once the lid is snapped on. If you have screws small enough to go through the holes in the board, you may choose to drill a couple of holes for screw mounting the board in the case. Clearances should be right for the lid to snap fit into the case well.