Simple cable clamp (scallable) or ring :)

prusaprinters

<p>During designing something else i have realized that this is good simple cable clamp :)</p><p>It is fast and super easy to print. You can scale it to any size in the slicer.&nbsp;</p><p>Even you can deform it to be eliptic and catch a smaller bundle of cables.</p><p><strong>Personally i use the smallest circle model from the 3mf file.</strong></p><p>&nbsp;</p><p>If you do not need cable clamp, you can use it as a ring xD</p><p>&nbsp;</p><p>On the site there are excelent regulated cable clamps, but sometimes something easy is also usefull. Print if you like :)</p><p>&nbsp;</p><h3>Printing</h3><p>Print without support with PETG, PLA is not good here as the clamp must be flexible.</p><p>Scale it up to any size in the slicer. I have attached 3mf file with predefined scales. But you can deform it in any size :)</p><h3>Assembly</h3><p>To catch the cable first open clamp - pull one side down and the other one up, look on one of the photo.&nbsp;</p><p>To close it you have <strong>2 possibilities</strong>.&nbsp;</p><ol><li>Do same what you do to open it&nbsp;</li><li>or simply press two sides against each other. It is not possible (really hard) to open it in this way because of angles.</li></ol><p>&nbsp;</p><h3>Update</h3><p><strong>2022-04-15</strong> Added wall mount version. You can also scalle it to any size as i do not drill hole in the model (it will be deformed if scalled). I have done this by trick in the prusa slicer, negative volume.&nbsp;</p><p>You can use attached 3mf file with predefined sizes.&nbsp;</p><p>If you like to do custom scale, select some of the model from 3mf file.</p><p>Then scale it, but remember to scale negative volume too, but in opposite scale side, 1/scale. E.g. if you scale it by 2x (200%) then negative volume scale by ½ (50%).</p>