Simple BLTouch Mounting Jig for Geeetech A10

thingiverse

To mount the BLTouch on the A10, you must position it perfectly at a 90-degree angle while maintaining an exact 4mm gap between the pin and the printbed as you tighten the holder's bolts. I found this process tedious, so I created a simple jig to simplify things.\r\n\r\nBegin by attaching the BLTouch to the holder, then release the carriage's bolts that connect it to the holder. Next, place the jig under the holder, allowing it to support it. To secure the right bolt, slide the jig slightly to the left; for the left bolt, move it to the right. Once you've done this, your BLTouch should be properly aligned and at a safe distance of 4mm from the printbed.