Simple bird feeder

thingiverse

Human: the roof takes some effort to print fine. I'm about to make it better now. Once I get done with the printing part, it should function perfectly all right then. It's a bit too thin for any printer to print smoothly in my opinion, anyway. Anyway, after fixing that pesky roof, I'll deal with the hole immediately thereafter as well because, you see, I had forgotten to make an opening within one of its many constituent components beforehand! No problem there though; it's merely a short and tiny layer - roughly about 2-3 mm in height really - which would necessitate a drilling job afterwards indeed! Now just check out that bright orange model that you can see in front of me; well, to cut a long story short: I encountered an abrupt computer crash part way through printing because, alas, by some accidental miscalculation on my behalf this particular printing endeavour came to an unfortunate grinding halt rather unexpectedly; hence the print had partially materialized only before disaster struck. In order to rectify the current situation with haste, a wee bit of creative tinkering ensued when plastic was subsequently used to weld parts together. Oh look! For those who have not noticed yet - a nice makeshift trimmer string line doubles as hanger with adequate base structure as well: so it would definitely be sturdy enough to keep its form steady while it's perched atop even some picnic tables out in the open! Or perhaps elsewhere, one might guess, I suppose? If only my memory did not fail me once again, I would recollect those exact and specific measurement markings of approximately 200mm for both its height as well diameter which, come to think of it right about now - after double checking - does stand roughly around that same exact measurement dimension: about 200 mm on both counts you see...