Simple all-in-one(AIO) fish tank aquarium cover v1.0 (for ABS)

thingiverse

Make an all-in-one cover with a filter, lighting, and heater with a 3D printer. You can pull off a lot of filter and clean layout even in a 20 cube fish tank! ** A few notes - If you have a small fish (about Guppy), you must use a free filter at the entrance. One of them was sucked in but couldn't get out of it by his own strength, so he took it away. - When the lid touches water, it bends slightly. (Final modeling changes from 2mm to 3mm) - If the inlet is turned too tight or under pressure in the short direction, it will break easily. We have reinforced both diameter and thickness, but please be careful when assembling and setting.