Simple .44 six round holder and speedloader

thingiverse

Simple Speedloader for Smith & Wesson 629 6.5" Caliber 44 Magnum. Two-part design featuring a hole inside each part for two 8x4 round magnets. To facilitate easy printing, pause the job at 17.10 and 21.30 to insert the magnets. A G-code command such as M600 can be used to initiate this pause. The tight tolerance of the hole prevents the magnet from sticking to the extruder. Note that my red PETG requires a more difficult insertion; consider enlarging the hole with a knife for easier installation. Print two parts in different colors to distinguish between the top and bottom components. Maintain consistent magnet orientation for both parts to ensure easy replacement. A 1mm gap is included between the parts to indicate when the speedloader is full, but this may be too small. Increasing the gap can cause instability; please let me know if a larger gap would be more useful.