sim racing hydraulic e-brake 3d print parts

thingiverse

This is all the parts required to do the DIY hydraulic e-brake build for sim racing. These parts are all original. You can find a comprehensive guide on YouTube at https://www.youtube.com/watch?v=DOjBkmVstwM. **Print Settings** * Printer: Anet A8 * Rafts: No * Supports: No * Infill: 50% * Notes: All parts were printed using ABS. The extruder was set to 247 degrees and the bed was set to 105 degrees. All prints were created with a 10mm brim. The only print that requires support is the pot cover due to overhang, but everything else can be printed without supports. All prints have been completed at 50% infill. If you choose to skip the anchor connected to the master slave, increase the infill for the anchor to 80%. Spring retainers can be scaled according to the inner diameter of your spring. However, if using bushings, there is no need to print this part. All parts are at proper size. Parts that fit into existing holes are slightly larger, so use sandpaper for a snug fit. The same applies to any hole in prints to accommodate screws of the size you may be using. **Post-Printing** Bottom left: Slave cylinder anchor Bottom right: Spring retainers Pot holder and lever