Sim racing button plate (70mm)

thingiverse

Mount a 70mm PCD button plate behind your standard steering wheel. This device is designed for use with 12mm buttons and requires some adjustments to the holes, as they can be a bit too tight. Use a knife to scrape away any excess material from the edges of the holes to loosen them up. To install the buttons, simply hammer the nut into place in the back and then turn the button into it. Sorry for the poor lighting in my photos - I'll update them as soon as possible. This design is intended for magnetic paddle shifters found on Thingiverse at https://www.thingiverse.com/thing:2724966. To replace your standard G27 paddles, remove the existing paddles from their base and solder the wires to the pins located at the front of the hub board in the G27 controller. I used the outside and middle pins, but the inside pins also work. For more information on connecting buttons to the G27, check out my F1 style steering wheel design: https://www.thingiverse.com/thing:3023908. M3x30 screws are used to secure the back cover in place.