Sig Plastic Holster Mount P938/P290

thingiverse

My P938 came with a plastic OBW holster that I never use, the wrong hand being its major drawback. This bracket fits perfectly inside the belt loop of the holster, allowing it to be mounted on any vertical surface. It will also work with the holster that came with my P290RS, so I'm guessing it will work with most Sig holsters. Hole size is #4. It worked well with extra screws I had on hand. Print on its side for no supports, but not as strong at the bolt holes; print right side up with supports for better results. 3/14/2020: An extended version was added to allow the clip to be removed from the mount without removing it from the screws. It may need to be scaled down by 10x due to Fusion360 scaling error. The section where the clip attaches should be 3.8mm thick.