Sig P320 Mag Carrier, 2-Piece

thingiverse

This is actually a remix of the AMPoly Series: Single Glock Mag Carrier V2 from LaffDynamics on Odysee, full credit goes to him for the original design. I had my friend modify the files to create this new version. This mag pouch is designed for use with the Sig Sauer P320 9mm factory magazines. The fit is meant to be tight, but if you want it to be a bit looser, take some fine sandpaper and gently sand down the inside gripping surfaces a tad until the retention is what you like. Additionally, LaffDynamics' version had a very close fitting belt loop part that was too small for me to use with my daily carry belt, a Nextbelt Ratchet Belt, so I had the belt loop part enlarged and more space added between the belt loop and the carrier body. Works like a charm now. (When assembled, this belt loop can accommodate a belt up to 7mm thick by 38mm high.) The printing instructions are from his original design and worked well for this design too. What follows are the verbatim instructions he provided for assembly: Adhesive Used: Clear Gorilla Glue (Not Superglue) Assembly Directions: 1) Use sandpaper to roughen the tabs of the belt clip. 2) Apply Clear Gorilla Glue to the tab index slots of the mag carrier. 3) Clamp the carrier retaining belt mount to the carrier. Be sure the clip is parallel to the side of the carrier. 4) Wipe away adhesive squeeze-out. 5) Let the adhesive set for 2 hours clamped. Full cure time 24 hours. (But after the 2, I doesn't need to be clamped.) Notes: Note 1) The use of Clear Gorilla Glue was chosen to reduce design weight and hardware usage. (No screws needed) (note from me) Regarding printing supports: The ONLY supports that are needed are for the 4 square holes in the mag pouch. Print the pouch standing on its base. The clip should be printed with the four attachment points up. Huge thanks to LaffDynamics for the original design!