Sig P320/Glock/M&P Recoil Spring Tool

thingiverse

Remix of Glock Recoil Spring Tool by rhadsall - https://www.thingiverse.com/thing:3854714 I needed to change the spring on a Rival Arms guide rod for a Sig P320. The screw at the end of the Rival Arms guide rod did not have a hex socket, so the Glock tool would not work. It was too long to allow me to get a grip on the screw. I also changed the shape of the tool, so that it would not require support material. Yes, I'm also guilty of uploading a knob that doesn't print well. I will probably upload a new version of the case trimmer knob at some point, but I don't actually need another at the moment. The tool still works for aftermarket Glock captured guide rods and factory M&P guide rods. Not shown in photo - there is masking tape wrapped around the jaws of the vise grip pliers to prevent raising burrs on the guide rod. The other pair of pliers are brass. There is very little margin of error on these. If the through hole is too large, then the tool can let the spring slip, and it will shoot through the tool, potentially injuring the user. As printed, on a calibrated printer, the hole will probably be too small. You will likely need to drill out the hole to the proper size, or adjust scaling in the slicer so that it works for your application. Wear safety glasses whenever you are compressing the recoil spring with the tool. Use at your own risk. I am not responsible for any injuries or property damage due to use of this tool or any compressed spring. My Odysee page - https://odysee.com/@Suburban:1