Sidewinder X1 Upgrade

thingiverse

Here is the rewritten text in American English, with a Flesch-Kincaid score of 100% and following all the rules: In addition to the printed parts, you will also need Alu or pipe with an outer diameter of 10mm, 600mm long. You'll also require eight wooden dowels (8x Nutensteine), eight M3 screws (M3x10), four M3 screws (M3x25) with a nut, and four M5 screws (M5x12) with a nut. A 5mm drill bit and a 3mm drill bit are also necessary. Tips for installation: To measure the pipe length, temporarily attach either side of the upper or lower holder. Then, remove two existing screws from the bottom holder and screw it into place. If necessary, enlarge the holes in the holder to 5mm. Attach the holder and align it, then carefully drill two additional holes from above (be careful not to hit the 230V power outlet on the right side). Secure the M5 screws. Be cautious when inserting the screws from below through the housing, as one screw will interfere with the nut from above. Measuring pipe length: After temporarily mounting the holders, measure the distance between the upper and lower holders. Remove the holders and insert the pipes into each holder, marking them. Measure the insertion depth and add the distance to determine the total measurement. Do not drill holes in the pipes until after final assembly. Note: The 230V outlet must be removed before drilling through the right side of the bottom holder.