Sidewinder X1 Side Bed Chain Mod

thingiverse

I wanted to get a better grasp on the bed cable for my Sidewinder X1, and I've seen some parts out there, but none of them really spoke to me, so I designed my own!. The bed mount is shaped to fit the X1 bed mount, there is a little gap around it to allow slight movement. Remove leveling nut and spring, install bed mount, then re-install spring and leveling nut. The gantry mount is designed to help hide some of the wiring, while still providing plenty of room for wires to pass through. This mount covers the square hole in the case where factory wiring passes through. I have ran my bed wires through here and added about 6" to the red heater wires only, I did not extend thermistor wiring. The mount uses an M5 screw and t-nut to attach to the Z-axis rail. The end stop for Z-axis will fit in the groove of the rail and pass right into the box. The mounts are designed to hold a 10x20 chain, I purchased mine from Amazon.