Sidewinder X1 Mirror Corner Piece

thingiverse

My local Home Depot offers Glacier 12 x 12 mirrors (6 pack) for approximately $11. The mirrors fit the stock bed almost perfectly but won't sit flat without using some kind of tape or adhesive. I prefer not to use that method, so I created these corner pieces that slide in with no problems at all. You might need to scale down the print by a percent or two, so it's best to print one up first and test it out. No supports are necessary, but you may have to lower the Z axis by 2mm if it's not sitting flush on the bed. You only need to use three (3) of the corner pieces since the nozzle will hit the bottom corner (0,0). The mirror from Home Depot can be found at: https://www.homedepot.com/p/Glacier-Bay-12-in-x-12-in-Plain-Edge-Bath-Mirrors-6-Pack-81175/205513215