Sidewinder X1 - BMG V6 Fan Duct w/ Stock Endstop (Inductive Sensor) Mount

thingiverse

Remix of 3DChanh's BMG V6/Volcano 4020 fan duct. Added a mount for a stock inductive sensor to be used as an ABL probe with Y offset of about -15 from the nozzle. The Z offset is about 1mm when the bed is heated to 60-70C. If using an SKR1.4 board, the min Z endstop pins don't support inductive sensors, so signal and ground cables were rerouted to the probe pins (5V still in the min Z endstop) and redefined in the firmware. Screw/bolts area was reinforced with some extra material and I added a spacer to enclose the fan, for shits and giggles. Some of the edges were also smoothed out a bit to reduce overhang and improve overall print quality. There's a small clip that can be printed to secure the sensor in the mount (though I've been using it without it and it hasn't been a problem). Print using a support blocker to prevent the PETG from being a pain in the ass to remove post-print. I used support density 8% with an 88% overhang. You'll need 2x M3 bolts to fasten this fan duct (minimum 25mm or so).