Side doors, shoe and lens protection for GoPro 6/7 mount for FPV drone

thingiverse

I modified the GoPro 6/7 mount by adding removable sides, a lens protector, and a shoe to reduce pitch angle. The sides can be secured with M3 sticky tape on the rear wall, allowing them to swing open freely. The lens protector should be bonded with CA for added security. Similarly, the shoe may also be glued to the camera mount. To minimize weight, I recommend printing with a wall thickness of 0.8mm and infill density of 20%. The top and bottom layers can be set to 0.4mm for optimal results. This design should fit mounts from Thingiverse: https://www.thingiverse.com/thing:2943015 https://www.thingiverse.com/thing:3052550 https://www.thingiverse.com/thing:3052566