Shrimp cave

thingiverse

Shrimp/small fish cave printed in PLA or PETG. I've used PLA in my tanks without any problems. Print with 100% infill or it wont sink. Be sure to get out the air bubbels between the pipes. If you still struggle to keep it down you can fill som gravel or sand in the bottom pipes alternative in the small gaps between the pipes. I've printed the cave many times without a brim, but if you struggle with bed adhesion this would help. The caves goes from 70-65-60mm in length. Internal diameter of the caves are about 15mm. Adjust the size in your slicer to your liking. Approximately 6 hours to print with 25mm/s. Be sure to set the wall count to minimum 3 so it becomes all walls and no time consuming infill patterns. Don't hesitate to contact me if there is any problems. If you like my design, a tip would be much appreciated. Thanks! :)